Command Page; Save - Yamaha A3000 Owner's Manual

This section describes the command screens (command pages) that you can access by pressing
the COMMAND key while working in RECORDING mode.

SAVE

Saves object(s) from memory to disk.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT
REC RECORD SETUP
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Knob 1
Knob 2 Type of Save

COMMAND Page

EFFECT SETUP CONTROL
FILTER EG LFO MIDI / CTRL
METER EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
-
Use this page to save the selected memory-resident object(s) to disk. You can elect to
save all programs, all samples and sample banks, the selected program only (together
with all samples used by that program), or a selected sample only.
• Push the knob when you are ready to execute the save. The A3000 returns a confir-
mation prompt. Push Knob 5 (>YES) to proceed with the save, or Knob 4 (>NO) to
cancel.
• If a name conflict occurs (if the selected object in main memory has the same name
as a corresponding object on the target volume), the A3000 prompts for instructions
about how to resolve the conflict. ( 100)
= All(wipe), AllPgm(wp), Edited, AllSmp, Smp(Bank)
Turn the knob to select the object(s) to be saved to disk. Selections are as follows.
All(wipe)
Saves all memory content to disk. This operation saves all ob-
jects currently in memory (all usable programs, all samples, and
all sequences) to the destination volume on disk. The operation
erases all data already existing in the destination disk volume.
[Note: a program is usable if it uses at least one sample or if its
"A/D In" setting is on.]
Press the COMMAND key, then turn Knob 1 to select >SAVE.
Knob 3 Knob 4
- -
>SAVE
Chapter 6
COMMAND Pages
Knob 5
-
RECORDING Mode
221