Monitor Function; Monitor - Monitor - Yamaha A3000 Owner's Manual

MONITOR Function

This function sets up the monitoring feature, so that you can monitor the input signal
as you record it. You can also use this function to generate a metronome click that you
can use to help time your recording.

MONITOR - Monitor

Sets up the input monitor.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to switch monitoring on or off, to select the monitor output, and to set the
monitor level.
Knob 1 Change Page
• Turn the knob to switch between the function's Monitor and Click pages.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Output
Knob 2
• Turn the knob to select the output location for the monitor signal.
• Note that the AS1&2, AS3&4, AS5&6, and DIG&OPT settings are effective only if
• This setting is forced to Stereo if the A3000 is taking its input from the DIGITAL or
Level
Knob 3
• Turn the knob to set the monitor's output level. (This setting does not affect the level
• Note that you cannot adjust this setting if using OPTICAL or DIGITAL input.
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
= Stereo, ASL&R, AS1&2, AS3&4, AS5&6, DIG&OPT
you have installed the optional AIEB1 expansion board.
OPTICAL connector (if the Input setting in the RecData page ( 227) is set to DIGITAL
or OPTICAL).
= 0,...,127
of the input signal.)
MONITOR Function
Turn Knob 1 to select Monitor.
Knob 3 Knob 4
-
- -
Select P/S
Chapter 6
Knob 5
-
RECORDING Mode
243