Yamaha A3000 Owner's Manual page 124

EFFECT Function
Knob 3
Knob 4
Knob 5
Chapter 4 PLAY Mode
122
Effect2 = Through, Scratch,...,Canyon
• Turn the knob to select the effect type to be applied as Effect 2. For information about
available selections, refer to the "Effect type list" in the appendix. ( 335).
• Push the knob to toggle Effect 2 on or off. Press once to switch the effect off (so that
a "- - -" appears above the knob); press again to switch the effect back on.
Effect3 = Through, Scratch,...,Canyon
• Turn the knob to select the effect type to be applied as Effect 3. For information about
available selections, refer to the "Effect type list" in the appendix. ( 335).
• Push the knob to toggle Effect 3 on or off. Press once to switch the effect off (so that
a — appears above the knob); press again to switch the effect back on.
Connect = 1/2/3, 1
Turn this knob to select the interconnection between the three effects blocks. Available
settings are as follows.
1/2/3
No interconnection — all effects blocks operate independently.
Samples whose main output destination is to Effect1 move
through the Effect-1 block only (receive Effect 1 only) and then
pass the A3000's stereo outputs. Similarly, samples with main
output destination set to Effect2 or Effect3 move through the
corresponding block only and then pass to the stereo outputs.
1 2/3
Feeds the Effect-1 block through the Effect-2 block. Specifi-
cally, output from the Effect-1 block passes through the Effect-2
block and then to the stereo outputs.
Operation is therefore as follows. Samples with destination set
to Effect1 receive both Effect 1 and Effect 2, and then pass to the
stereo outputs. Samples with destination set to Effect2 receive
Effect 2 only (and pass to stereo outputs). Samples with destina-
tion set to Effect3 receive Effect 3 only (and pass to stereo out-
puts).
1 2 3
Feeds the Effect-1 block to the Effect-2 block, and the Effect-2
block to the Effect-3 block. Samples with destination set to Ef-
fect1 receive all three effects. Samples with destination set to
Effect2 receive Effect 2 and Effect 3 only. Samples with destina-
tion set to Effect3 receive Effect 3 only. Again, all output from
the Effect-3 block passes to the stereo outputs.
Bypass
Bypass
2/3, 1 2 3