Advanced Uses (1); The Bypass Function; Pre-Effect Eq - Yamaha ProR3 Owner's Manual

12

Advanced uses (1)

Advanced uses (1)

The bypass function

When you press the BYPASS key, the circuit will be switched so that the input sound is output
directly. This function provides an easy way to make a quick comparison between the sound pro-
cessed by the effect program and the unprocessed sound. When the effect is bypassed, the red
indicator will light.

Pre-effect EQ

The PRE EFFECT EQ controls allow you to make settings for the three-band pre-effect equalizer.
For each band, you can set the center frequency and the gain.
1. Press the PRE EFFECT EQ ON key to turn on the equalizer.
The green indicator will light.
2. Select a band, and rotate its control knobs to adjust the gain.
3. Rotate the FREQ (frequency) control of the selected band.
To hear the effect of the equalizer, first adjust the gain level of the selected band, and then adjust
the frequency.
The equalizer control settings are not stored in the program memory. If the equalizer is turned
on, its settings will affect all programs.
ProR3 Digital Reverberator
Downloaded from: http://www.usersmanualguide.com/
PRE
EFFECT
EQ
Frequency
Gain
Note: The pre-effect equalizer controls are located in the circuit after the INPUT level meters. This
means that you need to be careful when setting gain levels, since even if the gain is raised excessively
and digital clipping occurs, this will not be indicated by the meters.
EFFECT
ON
LOW
50 Hz to 700 Hz 350 Hz to 5 kHz
±15 dB
BYPASS
MID HIGH
2 kHz to 20 kHz
±15 dB ±15 dB