Setup - Trigger - Yamaha A3000 Owner's Manual

SETUP Function

SETUP - Trigger

Selects the trigger types used to start and stop recording.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 6 RECORDING Mode
234
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
You use this page to set the type of triggers used to start and stop actual recording.
Change Page
• Turn the knob to change to a different page within the SETUP function. Available
pages are: RecData, Target, KeyRnge, Trigger (this page), and Process.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
StartBy
Turn the knob to set the type of trigger used to start recording. The setting determines
how the A3000 switches from standby into actual recording.
ManOnly
SrcIn
StopBy
Turn the knob to set the type of trigger used to stop recording.
ManOnly
SrcOut
CONTROL
MIDI / CTRL
Turn Knob 1 to select Trigger.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= ManOnly, SrcIn
Manual trigger only. The A3000 does not begin recording until
you push Knob 4 (>START) at the recording standby page ( 224)
The A3000 automatically begins recording when the input level
rises above the SrcIn level specified in the METER function's
TrgLvl page ( 237). But you are free to start recording earlier
than this by pushing Knob 4 (>START) at the standby page.
= ManOnly, SrcOut
Manual trigger only. The A3000 stops recording only when you
push Knob 5 (>FINISH) or Knob 2 (>STOP), or when you run
out of free memory.
The A3000 automatically stops recording when the input level
falls below the SrcOut level specified in the METER function's
TrgLvl page ( 237). But you are free to stop recording earlier
than this by pushing Knob 5 (>FINISH) or Knob 2 (>STOP).
Knob 4 Knob 5
- -
- -
Select P/S