Panel Play - Knobset - Yamaha A3000 Owner's Manual

PANEL PLAY Function

PANEL PLAY - KnobSet

Sets up knobs as controllers.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Knob 4
Chapter 8 UTILITY Mode
292
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
• Use this page to assign a controller number and Transmit channel to each of the
knobs you want to use as controller.
• To actually use the knobs as controllers, you must go to the KnobCtl page (or else use
the ASSIGNABLE key). ( 291)
Change Page
• Turn the knob to change to a different page within the PANEL PLAY function. Avail-
able pages are: KnobCtl, KnobSet (this page), and FKeySet.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Knob#
Select the knob you want to set up, by its knob number. You can then set the knob up
using Knobs 3 to 5, as described immediately below. You may then repeat this sequence
for each knob that you want to set up: first select the knob number with Knob 2, then
set the values using Knobs 3 to 5.
Ctrl
• This value sets the selected knob's control sensitivity-the amount by which the con-
trol value changes per increment of knob rotation. Set to on for minimum sensitiv-
ity, or to Step 1, Step 2, or Step 3 for greater sensitivity (where Step 3 gives the
highest sensitivity).
• Set the value to off if you want to disable use of the selected knob as a controller.
T-ch
• This value sets the "Transmit" channel for the selected knob's controller action. The
setting determines the channel over which the knob-generated control-change data
is transmitted.
• Set the value to Bch if you want to use the channel selected by the BasicCh param-
eter in the UTILITY | MIDI Receive page ( 305).
• Push the knob if you want to set the channel from an external MIDI device. The knob
indicator begins blinking, indicating that the A3000 is ready to receive MIDI input.
Now transmit any channel message from the MIDI device; the A3000 detects the
channel and displays the value over the knob. Lock in the setting in by pushing the
knob again or by switching to a different screen.
CONTROL
MIDI / CTRL
Turn Knob 1 to select >KnobSet.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= 2,...,5
= off, on, Step1, Step2, Step3
= 1,...,16, Bch
Knob 4 Knob 5
-
Select P/S
MIDI IN