Program Function; Program - Pgmload (Load Program(S)) - Yamaha A3000 Owner's Manual

PROGRAM Function

You use the PROGRAM function to load one or all programs from a floppy disk or SCSI
disk volume into the A3000 main memory. Before using this function, you must select
the source disk or volume using the DISK or VOLUME function.
• If loading from a floppy disk, you must first insert the floppy disk into the A3000
• If loading from a SCSI disk, you must first select the disk (partition) and volume
For details about the relationship between disks, partitions, and volumes, refer to the
section entitled "Disks and Volumes" in Chapter 3. ( 81)
FYI
Before you can load programs, you must first save them to disk. You can save your
programs to disk using the PLAY | PROGRAM function. ( 110)

PROGRAM - PgmLoad (Load Program(s))

Loads one or all programs from disk.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to select and load one or all programs, together with all samples used by
these programs.
FYI
If you want to load a program from disk into a different program number in memory
(for example, Program 001 from disk into Program 003 in memory), you should first
select the disk-side program at this page, and then press the COMMAND key and use
Knob 3 or 4 to select the program number for the destination program. ( 249)
floppy drive, and then select the disk at the DISK function. ( 268)
containing the program(s) you want to load. ( 268, 266)
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
-
PROGRAM Function
Knob 3 Knob 4
- -
-
Chapter 7
Knob 5
-
DISK Mode
259