Master - Stout (Stereo Output Assignment) - Yamaha A3000 Owner's Manual

Yamaha professional sampler owner's manual a3000
Hide thumbs Also See for A3000:
Table of Contents

Advertisement

MASTER - StOut (Stereo Output Assignment)

Selects an assignable-output destination for the stereo-output signal. Also, sets the "level offset" for the stereo output.
PLAY
PROGRAM
SAMPLE
EASY EDIT
EDIT
TRIM / LOOP
MAP / OUT
FILTER
REC
RECORD
SETUP
METER
DISK
PROGRAM
SAMPLE
SEQUENCE
UTILITY
TOTAL EQ
PANEL PLAY
SEQUENCE
Turn action
Push action
Use this page to adjust the level to the stereo outputs. You can also select an assignable-
output destination for the stereo output signal — so that the stereo-output jacks and
the selected assignable-output connectors produce exactly the same signal.
Important
The setting that you make at this page takes precedence over the assignable-output
settings within samples and programs. If you select AS2&3 at this page, for example,
then AS2&3 will always produce the same signal as the stereo outputs.
Knob 1
Change Page
• Turn the knob to switch between the function's Tuning and StOut pages.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
To AsgnOut
Knobs 2, 3
• Set this value to off if you do not want to pass the stereo-output signal to any assign-
• If you have installed the AIEB1 board, you may also select from among the other
Level Offset
Knobs 4, 5
• Use this setting to raise the level to the stereo outputs.
• Note that higher settings may produce distortion with certain types of sound, or
EFFECT
SETUP
CONTROL
EG
LFO
MIDI / CTRL
EFFECT
EXT CTRL
MONITOR
VOLUME
DISK
IMPORT
MASTER
SYSTEM
MIDI
Knob 1
Knob 2
-
= off, ASL&R, AS1&2, AS3&4, AS5&6, DIG&OPT
able output. Set the value to ASL&R if you want to pass the signal to the A3000's
standard assignable-output pair. The other settings are meaningful only if you have
installed the optional I/O expansion board (AIEB1 board); if the board is not installed,
these settings are equivalent to off.
assignable-output pairs indicated above. If you select DIG&OPT, the A3000 transmits
the same signal to both the DIGITAL and the OPTICAL output jacks.
= -0dB,...,+24dB
when many notes are played at the same time.
MASTER Function
Turn Knob 1 to select StOut.
Knob 3
Knob 4
-
-
Select P/S
Chapter 8
Knob 5
-
UTILITY Mode
299

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents