Disk - Selfid - Yamaha A3000 Owner's Manual

DISK - SelfID

Sets the SCSI ID of the A3000.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to set the SCSI ID of the A3000.
Important
• There is generally no need to change the ID from its factory setting (ID 7). You will
• Be sure that the ID that you set here does not match the ID of any other device in
• The ID that you set here does not become effective until you switch the power off and
Knob 1 Change Page
• Turn the knob to change to a different page within the DISK function. Available
• Push the knob to move to the Program/Sample Selection screen. ( 95)
A3000 ID
Knob 2
Turn the knob to set the new ID. (The new setting does not become effective until you
switch power off and then back on.)
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
need to make this change only if you are connecting up another SCSI device that has
a fixed (unchangeable) ID of 7.
your system — since all devices must have different IDs. To check for currently used
IDs, use the Config page ( 270).
then back on.
pages are: Disk, Config, and SelfID (this page).
= 0,...,7
DISK Function
Turn Knob 1 to select SelfID.
Knob 3 Knob 4
- -
- -
Select P/S
Chapter 7
Knob 5
-
-
DISK Mode
271