Resmpl - Tmstrch (Resampling - Time Stretch) - Yamaha A3000 Owner's Manual

RESMPL - TmStrch (Resampling - Time Stretch)

Lengthens or shortens the selected sample without changing its pitch.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
The Resampling command page gives you access to two different commands: Time Stretch
(described here), and Pitch Conversion ( 153). Select either of these operations by
turning Knob 2.
You use the Time Stretch command to lengthen or shorten the playback time of the
selected sample. The adjustment does not affect the sample's pitch.
Important
• This command does not operate on sample banks.
• The command lengthens or shortens the entire waveform. (Operation is not restricted
• Time conversion may produce unexpected results with some samples. It is recom-
• Following time conversion, the "start address" and "loop start address" reset to the
Knob 1 Change Page
• Turn the knob to change to a different command page.
• Push the knob to execute the time conversion. The A3000 returns a confirmation
Func
Knob 2
• Turn the knob to select the command you want to execute: Time Stretch or Pitch
• Push the knob to hear how the converted sample will sound. This feature lets you
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
to the area between the start and end addresses.)
mended that you limit adjustment to 10% in either direction, except in cases where
you are trying to achieve an unusual effect.
wave-start address (=0), and the "end address" and "loop end address" reset to the
wave-end address.
screen. Push Knob 5 (>YES) to proceed, or Knob 4 (>NO) to cancel.
=TmStrch, PtchCnv
Conversion.
confirm that results will be appropriate before you execute the actual conversion.
Press the COMMAND key, turn Knob 1 to select >RESMPL,
then turn Knob 2 to select TmStrch.
Knob 3 Knob 4
- -
>RESMPL
>Test
Chapter 5
COMMAND Pages
Knob 5
-
EDIT Mode
151