Command Pages; Save - Yamaha A3000 Owner's Manual

COMMAND Pages

This section describes the command screens (command pages) that you can access by pressing
the COMMAND key while working in PLAY mode.

SAVE

Use this page to save object(s) to disk.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Chapter 4 PLAY Mode
98
COMMAND Pages
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to save the selected memory-resident object(s) to disk. You can elect to
save all programs, all samples, the selected program only (together with all samples
used by the program), or a selected sample only.
Change Page
• Turn the knob to change to a different command page.
• Push the knob when you are ready to execute the save. The A3000 returns a confir-
mation prompt. Push Knob 5 (>YES) to proceed with the save, or Knob 4 (>NO) to
cancel.
• If a name conflict occurs (if the selected object in main memory has the same name
as a corresponding object on the target volume), the A3000 prompts for instructions
about how to resolve the conflict. ( 100)
Type of Save
Turn the knob to select the object(s) to be saved to disk. Selections are as follows.
All(wipe)
CONTROL
MIDI / CTRL
Press the COMMAND key, then turn Knob 1 to select >SAVE.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= All(wipe), AllPgm(wp), Edited, AllSmp, Pgm
Saves all memory content to disk. This operation saves all ob-
jects currently in memory (all usable programs, all samples, and
all sequences) to the destination volume on disk. The operation
erases all data already existing in the destination disk volume.
[Note: a program is usable if it uses at least one sample or if its
"AD In" setting is on.]
Knob 4 Knob 5
- -
>SAVE