Meter - Trglvl - Yamaha A3000 Owner's Manual

METER - TrgLvl

Sets the recording trigger levels.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
• Use this page to set the input levels required to start and stop recording. These set-
• Use the SrcIn value to set the level for the recording start trigger. Use SrcOut to set
• You can use the monitor feature to listen to the sound of the signal while this page is
Knob 1 Change Page
• Turn the knob to switch between the function's Meter and TrgLvl pages.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
SrcIn
Knob 4
• This value sets the input level that triggers the start of recording. The setting is
• The display's upper-level triangle mark ( ) points to the position of the SrcIn level on
SrcOut
Knob 5
• This value sets the input level that triggers the end of recording. The setting is mean-
• The display's lower-level triangle mark ( ) points to the position of the SrcOut level
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
-
tings are effective only if you have selected SrcIn and/or SrcOut triggering at the
SETUP Trigger page ( 234).
the level for the stop trigger.
on the display. Use the MONITOR function ( 243) to switch monitoring on or off,
and to select the output destination for the monitor signal.
= 0,...,63
meaningful only if you have set the Trigger page's StartBy parameter to SrcIn.
the graphic level meter.
= 0,...,63
ingful only if you have set the Trigger page's StopBy parameter to SrcOut.
on the graphic level meter.
METER Function
Turn Knob 1 to select TrgLvl.
Knob 3 Knob 4
-
- -
Select P/S
Chapter 6
Knob 5
-
RECORDING Mode
237