Yamaha ACD1 Manuals

Table of Contents

• • 2

    Table of Contents

• 3

  Introduction

  • 3

    About the Documentation
  • 3

    Supported Amplifiers
  • 3

    Setup
  • 4

    Terms

• 5

  Controls and Connectors

  • 5

    Front Panel
  • 6

    Rear Panel

• 7

  Panel Operations

  • 8

    Basic Operation
  • 10

    Scene ("1. Scene")
    • 10

      Recalling a Scene ("1. Scene" ➝ "Recall")
    • 10

      Storing a Scene ("1. Scene" ➝ "Store")
  • 11

    Controlling an Amplifier ("2. Amp Control")
    • 11

      Power On/Standby ("2. Amp Control" ➝ "Standby")
    • 11

      Mute ("2. Amp Control" ➝ "Mute")
    • 11

      Attenuator Value Adjustment ("2. Amp Control" ➝ "Attenuation")
  • 12

    Amplifier Output Monitor ("3. Output Monitor")
    • 12

      Amplifier Output ("3. Output Monitor")
  • 12

    Device Setup ("4. Device Setup")
    • 12

      Device ID Setting ("4. Device Setup" ➝ "Device ID")
    • 12

      View ACD1 Name ("4. Device Setup" ➝ "Device Label")
    • 13

      Identify ("4. Device Setup" ➝ "Identify")
  • 13

    Utility ("5. Utility")
    • 13

      Backup Battery Check ("5. Utility" ➝ "Battery")
    • 13

      Version Indication ("5. Utility" ➝ "Firmware Ver.")
    • 14

      LCD Backlight ("5. Utility" ➝ "LCD Backlight")
    • 14

      Restricting Panel Operations ("5. Utility" ➝ "Panel Operation")
    • 14

      Enabling Scene Recall Operations From the Panel ("5. Utility" ➝ "Scene Recall")
    • 15

      Enabling Scene Recall Operations Via EMG Commands ("5. Utility" ➝ "EMG Scene Setup")
    • 15

      LAST MEMORY RESUME Setting ("5. Utility" ➝ "Last Mem. Resume")
    • 15

      Clock Setting ("5. Utility" ➝ "Clock")
    • 16

      GPI in Calibration ("5. Utility" ➝ "GPI Calibration")
  • 16

    Network Settings ("6. Network Setup")
    • 16

      IP Address Mode Setting ("6. Network Setup" ➝ "IP Address Mode")
    • 16

      IP Address Setting ("6. Network Setup" ➝ "IP Address")
    • 16

      Checking the MAC Address ("6. Network Setup" ➝ "MAC Address")
    • 17

      Port Settings for an External Controller ("6. Network Setup" ➝ "IP Ctrl Port #")
  • 17

    Initializing the ACD1

• 18

  Connector Wiring

  • 18

    Euroblock Plug Connection
  • 19

    GPI Connector
  • 20

    FAULT OUTPUT Connector

• 21

  Appendix

  • 21

    Display Messages
  • 21

    List of Supported Characters
  • 22

    Troubleshooting
  • 22

    Specifications
  • 23

    Control I/O
  • 23

    Pin Assignment
    • 23

      Monitor/Remote
    • 23

      Data Port
  • 24

    Dimensions