Effect Function; Effect - Eftype (Select The Effect Types) - Yamaha A3000 Owner's Manual

This section describes the PLAY-mode EFFECT function. You use this function to set up
the program's effects.
Important
• The sample's "main output" destination determines the effect that the sample re-
• Note that you can also adjust the "main output" setting using the Easy Edit function.

EFFECT - EfType (Select the Effect Types)

Selects effect types and effect-block interconnection for the program.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to assign a specific effect to each of the effect blocks (Effect 1, Effect 2, and
Effect 3), and to set the interconnection (if any) among these blocks.
Knob 1 Change Page
• Turn the knob to change to a different page within the EFFECT function. Available
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Effect1
Knob 2
• Turn the knob to select the effect type to be applied as Effect 1. For information about
• Push the knob to toggle Effect 1 on or off. Press once to switch the effect off (so that

EFFECT Function

ceives. In particular, the A3000 does not apply any effect to samples whose main
output is set to off or to Stereo. To apply an effect to a sample, make sure that the
sample's main output is set to Effect1, Effect2, or Effect3. ( 176)
( 119).
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
pages are: EfType (this page), Efct1, Efct2, Efct3, In&Out, and EdType.
= Through, Scratch,...,Canyon
available selections, refer to the "Effect type list" in the appendix. ( 335).
a "- - -" appears above the knob); press again to switch the effect back on.
EFFECT Function
Turn Knob 1 to select EfType.
Knob 3 Knob 4
Select P/S
Bypass
Chapter 4
Knob 5
-
PLAY Mode
121