Eg - Pegmode (Peg Mode Settings) - Yamaha A3000 Owner's Manual

EG - PEGMode (PEG Mode Settings)

Sets up the PEG's scaling, velocity sensitivity, and range.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to determine how PEG rates vary with velocity and keyboard location, and
how the PEG levels vary with velocity. Also use it to set the range for the PEG levels.
Knob 1 Change Page
• Turn the knob to change to a different page within the EG function. Available pages
• Push the knob to move to the Program/Sample Selection screen. ( 95)
RateScl
Knob 2
This setting determines how the PEG rates (attack, decay, and release rates) vary ac-
cording to keyboard location (pitch) of the played note. Set the value to 0 to keep rates
the same for all keyboard notes. Positive settings cause rates to increase as you move up
the keyboard, while negative settings cause rates to decrease as you move up the key-
board.
Vel
Knob 3
This value sets the velocity sensitivity for the PEG rates: the amount by these PEG rates
(attack, decay, and release rates) vary in response to the velocity (force) of the played
note.
Set the value to 0 to keep rates the same for all velocities. Positive settings cause rates to
increase as velocity increases, while negative settings cause rates to decrease as velocity
increases.
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode, PEGRate, PEGLevel, and
PEGMode (this page).
= -7,...,+7
Rate = -63,...,+63
Turn Knob 1 to select PEGMode.
Knob 3 Knob 4
- -
Select P/S
Chapter 5
EG Function
Knob 5
-
-
EDIT Mode
201