Lfo Function; Lfo - Common - Yamaha A3000 Owner's Manual

You use the LFO function to set up the sample's LFO (low-frequency oscillator). The
LFO applies a low-frequency modulation to the output volume, filter cutoff frequency,
and pitch.
FYI
The COMMAND key gives you rapid access to a number of helpful commands while you
are working with this function. For example, you can use the COMMAND key when you
want to save your edit results to disk, or when you want to cancel your new changes and
restore the previously saved data. ( 147)

LFO - Common

Sets the basic LFO parameters.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push action
Use this page to set the basic LFO parameters — wave type, oscillation speed, delay, and
phase synchronization.
Knob 1 Change Page
• Turn the knob to change to a different page within the LFO function. Available pages
• Push the knob to move to the Program/Sample Selection screen. ( 95)

LFO Function

EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
are: Common (this page), FltrMod, PtchMod, and AmpMod.
Turn Knob 1 to select Common.
Knob 3 Knob 4
- -
Select P/S
Chapter 5
LFO Function
Knob 5
-
EDIT Mode
203