Eg - Peglevel (Pitch-Eg Levels) - Yamaha A3000 Owner's Manual

EG Function

EG - PEGLevel (Pitch-EG Levels)

Sets the levels for the pitch EG.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Knob 4
Knob 5
Chapter 5 EDIT Mode
200
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page together with the PEGRate page ( 198) to set up the sample's PEG (pitch
envelope generator). The PEG determines how the pitch varies over time as each note
plays out.
The PEGLevel page (this page) sets the PEG's levels (initial, attack, sustain, and release).
The PEGRate page sets the PEG's various rates (attack, decay, and release rates).
Change Page
• Turn the knob to change to a different page within the EG function. Available pages
are: AEG, AEGMode, FEGRate, FEGLevel, FEGMode, PEGRate, PEGLevel (this page),
and PEGMode.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Init
This value sets the initial level (the pitch offset applied at time of Note On).
Attack
This value sets the attack level. (See illustration, page 198.)
Sustain
This value sets the sustain level. (See illustration, page 198.)
Release
This value sets the release level. (See illustration, page 198.)
CONTROL
MIDI / CTRL
Turn Knob 1 to select PEGLevel.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= -127,...,+127
= -127,...,+127
= -127,...,+127
= -127,...,+127
Knob 4 Knob 5
- -
Select P/S