Setup - Adsetup (A/D-In Setup) - Yamaha A3000 Owner's Manual

SETUP Function

SETUP - ADSetup (A/D-In Setup)

Sets the A/D-in feature on or off, and sets the A/D-input source and pan.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 4 PLAY Mode
132
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
The A/D-input feature lets you feed an acoustic signal from an external device (typically
a microphone) through the A3000. You can set the signal to receive any one of the
program's three effects, or you can relay the signal through the A3000 without change.
You use this page to set the program's A/D-Input feature on or off, and to set the A/D
input source and pan.
Important
It is not possible to use the digital connectors on the optional I/O expansion board
(AIEB1 board) as the A/D input source.
Change Page
• Turn the knob to change to a different page within the SETUP function. Available
pages are: PgmMstr, Portmnt, ADSetup (this page), and ADOut.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
A/D In
Turn this knob to switch the A/D-input feature on or off.
Source
Selects the input for the acoustic signal.
L/R
L+R
L
CONTROL
MIDI / CTRL
Turn Knob 1 to select ADSetup.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= off, on
= L/R, L+R, L
Use input stereo signal; handle the signal as stereo.
Use input stereo signal, but handle as monaural (mix the incom-
ing L-channel and R-channel signals).
Use monaural input received on the left channel. (Select this
setting when using a monaural microphone. Be sure to connect
the microphone to the "L" connector on the A3000.)
Knob 4 Knob 5
-
- -
Select P/S