Yamaha A3000 Owner's Manual page 81

FYI
• You can set the output so that the signal to the STEREO OUT jacks also passes to the
• You can use a program's Easy Edit feature to change the output destination for any
Triple Effect System
The A3000 allows each program to use up to three effects. The three effects are imple-
mented as independent, parallel circuits. It is also possible, however, to "rewire" any or
all of these circuits into a serial configuration ( 121).
Important
As the above illustration suggests, the sample's "main output" setting selects the effect
circuit to which the sample's output passes. Notice that the sample does not select the
actual effect itself (reverb, delay, and so on). The effects themselves are assigned sepa-
rately by each program.
Program
Sample
off
Stereo
Main Output
Effect1
Effect2
Effect3
generation Sound
off
ASL&R
Assignable
Output
AS1&2
AS3&4
AS5&6
DIG&OPT
DIGITAL OUT and OPTICAL OUT jacks or to any ASSIGNABLE OUT pair. You make
this setting using the StOut ("Stereo Out") parameter, located in the UTILITY mode's
MASTER function. ( 299)
sample within the program. The change is effective at the program level only, and
does not alter the output settings within the sample itself.
Sample Output Destinations and Effects
Effect1
STEREO OUT, PHONES
Mix
Effect2
Effect3
ASSIGNABLE OUT (L, R)
ASSIGNABLE OUT (1, 2)*
ASSIGNABLE OUT (3, 4)*
ASSIGNABLE OUT (5, 6)*
DIGITAL OUT,* OPTICAL OUT*
*These jacks are available only
if the optional AIEBI expansion
board is installed.
Chapter 3 Basics
79