Error And Recovery Procedure; Table 5-3 Error And Recovery Procedure - Seiko RP-F10 Series Technical Reference

5.2 ERROR AND RECOVERY PROCEDURE

When an error occurs, the printer stops printing operation. However, the data receiving is enabled. The table
below shows errors and their recovery procedures.
Error
Return-waiting
Output buffer full
Out-of-paper error
Cover open error
Cutter error
Voltage error
Head temperature error
Hardware error
*: This indicates the priority when multiple errors occur simultaneously. The bigger number indicates higher priority.
For example, when "Cover open error" and "Out-of-paper error" occur simultaneously, the LED shows "Cover open error" which has
the higher priority.

Table 5-3 Error and Recovery Procedure

Detail
The printer becomes this state
after releasing out-of-paper error,
cover open error, cutter error or
voltage error.
Output buffer of the printer is full.
There is no thermal paper.
The paper cover is open.
Cut failure due to paper jam at
cutting.
The power voltage is out of the
allowable range.
Head temperature rises to 85°C
(185°F) or higher.
An abnormality occurs in the
thermal head or the circuit board.
Recovery Procedure
The return-waiting state is
released 1 second later, and
the printer becomes print-ready
state.
Read response data from the
host device.
Open the paper cover, load
thermal paper, and then close
the paper cover.
Close the paper cover.
Open the paper cover to
remove the error cause and
close the paper cover, the
printer automatically recovers.
If the paper cover is not open
or the printer does not
automatically recover, see
"Cutter Error Treatment" in the
USER'S GUIDE.
The printer automatically
recovers when the voltage is
returned to the allowable range.
The printer automatically
recovers when head
temperature becomes 80°C
(176°F) or lower.
Recovery is not possible.
Request for repair.
5-3
*
Priority
-
1
2
3
4
5
6
7