Table 4-28 Bluetooth Setting (Ms39) - Seiko RP-F10 Series Technical Reference

16. Bluetooth Setting (MS39)
MS39 is enabled only when executing data input/output by Bluetooth.
• iOS Auto Connection Selection (MS39-1)
Once this function is enabled and when iOS device connection is disconnected, the printer tries to
reconnect to the iOS device last connected.
Use this function when using the printer exclusively with a specific iOS device.
Disable this function when using the printer with multiple iOS devices.
When the iOS device to use is changed, disable this function once and enable it after pairing is
completed.
• Security Mode Selection (MS39-2)
As the security mode, SSP (Mode4, Just Works) or PIN Code (Mode2) can be selected. Even
when SSP is selected, the printer is paired by PIN code if the Bluetooth host device does not
support SSP.
PIN code can be set by "Set Communication Default Value" command (DC2 'i').
Set this function to SSP usually.
• Inquiry Response Selection (MS39-3)
The Response function to a search from the Bluetooth host device can be selected.
When Always is selected, the printer always responds to the search from the Bluetooth host device,
so pairing is always available.
When Pairing Mode is selected, the printer enters pairing mode for about 60 seconds by pushing
the POWER Switch for 7 seconds or more with the printer off state. During the pairing mode, the
LED blinks twice per second. During this time, pair the printer with the host device.
• Association Model Selection (MS39-4)
As the SSP association model, Just Works or Numeric Comparison can be selected.
When Numeric Comparison is selected, the printer prints a 6-digit authentication code when
pairing with the Bluetooth host. When thermal paper is not loaded in the printer, the pairing is
canceled due to out-of-paper error.
Confirm that the printed authentication code corresponds with the code displayed on the Bluetooth
host, and approve the Bluetooth host.
The pairing is completed when the FEED Switch on the printer is pressed.
The pairing is canceled when the POWER Switch on the printer is pressed.
When neither switch is pressed, the printer times out in about 30 seconds and cancels the pairing.
• Reserved (MS39-5 to 8)
MS
iOS Auto Connection
39-1
(Auto Connection)
Security Mode Selection
39-2
(Security Mode)
Inquiry Response Selection
39-3
(Inquiry Response)
Association Model Selection
39-4
(AssocModel)
39-5 to 8 Reserved

Table 4-28 Bluetooth Setting (MS39)

Function
Value
0
Enable
PIN code
(PIN)
Always
Numeric Comparison
-
4-20
1
Disable
SSP
Pairing Mode
Just Works
Fixed