Dc3 '(' 'R' 'E' 'S' 'E' 'T' Dc3 'R' 'E' 'S' 'E' 'T' '); Printer Reset; Dc2 '>' N Specify Fixed Division - Seiko RP-F10 Series Technical Reference

Notes This is a realtime command.
This command is executed only at an error.
This command is executed only when Data Discard Selection When Error Occurs is enabled.
The operation of this command differs depending on the Function Setting MS13-3 (Realtime
Command Selection).
･ When the Function Setting MS13-3 (Realtime Command Selection) is enabled:
This command is valid.
Notes when using a realtime command:
The user should note that the same behavior as this command occurs when the code
line matching the code that comprises this command is received. For example,
graphics data contains such code line.
･ When the Function Setting MS13-3 (Realtime Command Selection) is disabled:
This command is ignored.

DC3 '(' 'r' 'e' 's' 'e' 't' DC3 'r' 'e' 's' 'e' 't' ')'

Code 13H 28H 72H 65H 73H 65H 74H 13H 72H 65H 73H 65H 74H 29H
Function Resets the printer.
Performs the same operation as when turning on the power. (For USB connection,
communication is not disconnected, but the buffer is cleared.)
Notes This is a realtime command.
The operation of this command differs depending on the Function Setting MS13-3 (Realtime
Command Selection).
･ When the Function Setting MS13-3 (Realtime Command Selection) is enabled:
This command is valid.
After sending this command, do not send any data until the initialization is completed by
the reset.
Notes when using a realtime command:
The user should note that the same behavior as this command occurs when the code
line matching the code that comprises this command is received. For example, graphics
data contains such code line.
･ When the Function Setting MS13-3 (Realtime Command Selection) is disabled:
This command is ignored.
DC2 '>' n
Code 12H 3DH n
Definition Range
Function Specifies the thermal head driving method to fixed division.
n specifies the number of divisions.
Notes When this command is input, the thermal head driving is specified to the fixed division
method.
The initial state can be determined by MS4-1 to 2 (Number of Dots Selection for Fixed
Division and Dynamic Division).
0 ≤ n ≤ 1
n
0 Fixed 2-division
1 Fixed 3-division
Number of Divisions
6-101

Printer Reset

Specify Fixed Division