Figure 4-5 Setting Value Selection Message (Example: Selected Standby Led); Figure 4-6 Setting Value Confirmation Message (Example: Selected Green) - Seiko RP-F10 Series Technical Reference

6. A message for selecting the setting value of the selected function is printed as a sample shown in
Figure 4-5.
Press the FEED Switch the number of times corresponding to the selected setting value number, and
then press the POWER Switch.
7. A message for confirming the selected setting value is printed as a sample shown in Figure 4-6.
Press the FEED Switch to save the setting value to the memory. Figure 4-3 is printed.
Press the POWER Switch to discard the selected item. A message of function selection is printed as a
sample shown in Figure 4-4. If select "0 : Return to MS Selection" there, function selection is not
performed, and Figure 4-3 is printed.
To continue to set functions, return to 4.
8. To exit the Setting Mode, select "0 : Exit" in Figure 4-3.
The test print and Figure 4-2 printing start again. Verify that the functions are properly set.
[Standby LED]
0 : Return to function selection.
1 : Aqua
2 : Green
3 : Off
4 : Blue
Press the FEED switch an equal
number of times to the selected number.
After that, press the POWER SW.
・When pressing the FEED Switch twice, "2 : Green" is selected.
Figure 4-5 Setting Value Selection Message
(Example: Selected Standby LED)
[Standby LED]
Set Green
Save setting : Feed SW
Discard setting : Power SW
Figure 4-6 Setting Value Confirmation Message
(Example: Selected Green)
4-5