Precautions For Use Bluetooth - Seiko RP-F10 Series Technical Reference

Refer to the following for the pairing procedure when using our utility software.
• NFC using:
Set the Bluetooth function and NFC function of host device to on, and start our utility software.
Tap the "Printer selection" column of software and slide to "NFC SEARCH".
Turn on the printer, and bring the NFC antenna of host device closer to the position of N mark on
the printer.
Pairing is started.
• QR Code using:
Set the Bluetooth function of host device to on, and start our utility software.
Tap the "Printer selection" column of software and slide to "QRCODE SEARCH".
Perform the test print. For the method of test print, see "4.3 TEST PRINT".
Read the QR Code printed on the test print with the camera of host device.
Pairing is started.
(3) Security
When MS39-2 (Security Mode Selection) is set to SSP (Simple Secure Pairing) in Function Settings,
the Bluetooth host device is connected by SSP.
When the host device does not support SSP or the security mode is set to PIN in Function Settings, the
Bluetooth host device is connected by PIN code.

3.3.2 Precautions for Use Bluetooth

(1) Precautions for Bluetooth Data Transmission
Check the printer status when the data is transmitted. In addition, do not transmit the data exceeding
the input buffer (4096 bytes) if the printer is not in printable status.
(2) Precautions for Disconnecting Bluetooth Connection
Before disconnecting Bluetooth connection, make sure the completion of transmitted data process by
executing "Execution Response Request" command (DC2 'q').
3-11