Gs 'V' M (2)Gs 'V' M N; Cut Paper; Esc I Full Cut; Esc M Partial Cut - Seiko RP-F10 Series Technical Reference

(1)GS 'V' m
(2)GS 'V' m n
Code (1)1DH 56H m
(2)1DH 56H m n
Definition Range
Function Feeds the thermal paper to the specified paper cut position and cuts the paper at the position.
m
0, 48 Full cut
1, 49 Partial cut
65
66
Notes The command configuration, code, definition range, and some notes differ depending on the
value of m.
In the standard mode, this command is valid only when input at the beginning of the line.
[(1) GS 'V' m]
Cuts the thermal paper with the specified cutting method.
[(2) GS 'V' m n]
When n=0, the thermal paper is fed to the cut position and cut at the position.
When n≠0, the thermal paper is fed [n × basic calculation pitch] beyond the cut position and
cut.
The basic calculation pitch is set by the "Set Basic Calculation Pitch" command (GS 'P').
The vertical basic calculation pitch (y) is used for the paper feed length. Moreover, when
the calculation result is a fractional figure, it is corrected using the minimum pitch of the
printer, and the remainder is discarded.
When the Function Setting MS17-3 (Feed Backward Setting After Paper Cutting) is enabled
and the Function Setting MS1-3 (Mark Mode Selection) is disabled, after this command and
before the next print or paper feed command is executed, the thermal paper is fed backward
automatically to minimize the margin.
Related Commands DC2 'w', DC2 'l'
ESC i
Code 1BH 69H
Function Cuts the thermal paper by full cutting.
Notes In the standard mode, this command is valid only when input at the beginning of the line.
ESC m
Code 1BH 6DH
Function Cuts the thermal paper by partial cutting.
Notes In the standard mode, this command is valid only when input at the beginning of the line.
(1)m = 0, 1 , 48, 49
(2)m = 65, 66, 0 ≤ n ≤ 255
Paper feed to cut position + [n × basic calculation pitch] and full cut
Paper feed to cut position + [n × basic calculation pitch] and partial cut
Function
6-86

Cut Paper

Full cut
Partial cut