Figure 6-1 Mapping Of Character And Image Data - Seiko RP-F10 Series Technical Reference

The character and image data are mapped as shown in Figure 6-1.
Double
height
character
12
Reference Reference
point
point
After executing the "Select Page Mode" command (ESC 'L') or "Set Print Area in Page Mode"
command (ESC 'W'), be sure to specify mapping start position before sending the print data.
When the print data is sent without specifying the mapping start position, the mapping position will
be undefined.
3. Direction of data mapping
The printer can specify the direction of data mapping. See the "Select Print Direction in Page Mode"
command (ESC 'T') for details.
4. Processing of print command
The commands that involve a printing operation in page mode are the "Print and Return to Standard
Mode" command (FF) and the "Print Data in Page Mode" command (ESC FF). The print commands in
standard mode ("Line Feed" command (LF), "Print and Feed Forward" command (ESC 'J'), etc.) only
move the mapping start position without actually printing.
5. Processing of 1 line full print
When the line buffer for 1 line is filled up with character data, the subsequent data is mapped from the
beginning of the next line.
When the next line does not fit in the print area, the excess data is discarded.
12
Bit image
Reference
Reference
point
point

Figure 6-1 Mapping of Character and Image Data

Downloaded
bit image
or
NV graphics
or
Graphics
data stored
in print
Reference
Buffer
point
Reference
point
Raster bit
image
6-12
Barcode
Two-dimensional
barcode
HRI character
Reference
point