Table 4-23 General Setting 17 (Ms17) - Seiko RP-F10 Series Technical Reference

13. General Setting 17 (MS17)
• Paper Saving Setting (MS17-1 to 2)
Space between lines and line spacing can be reduced without decreasing the size of character or
graphic.
Mode1: Space between lines and line spacing are decreased to 0 dots.
Mode2: Space between lines and line spacing are decreased to 2 dots.
Mode3: Space between lines and line spacing are decreased to 4 dots.
Disable: No decrease.
(NOTE) Paper saving is not performed to blank lines contained in the graphics printing
data.
This function is only valid for character printing in standard mode.
When the following 2 conditions are met, the printer feeds paper by decreased
dot-lines from the last print position, and then cuts the paper.
･"Cut Paper" command (GS 'V') is transmitted.
･Line feed or space between lines exists after the last printed line.
• Feed Backward Setting After Paper Cutting (MS17-3)
After paper cutting, before the command accompanying the next printing or paper feeding is
executed, the paper is fed backward for 60 dots. The margin from the cut position to the print start
position can be reduced up to about 2 mm.
The paper is not fed backward by partial cutting.
MS
Paper Saving Setting
17-1 to 2
(Paper Saving)
Feed Backward Setting After Paper Cutting
17-3
(Backfeed After Cut)
17-4 to 8 Reserved

Table 4-23 General Setting 17 (MS17)

Function
Table 4-24 Paper Saving Setting (MS17-1 to 2)
MS17-2 MS17-1
0 0
0 1
1 0
1 1
4-18
Value
0
See Table 4-24
Enable
-
Paper Saving Setting
Mode1
Mode2
Mode3
Disable
1
Disable
Fixed