Send Registered Nv Graphics Key Code List; Delete Nv Graphics Data In Batch - Seiko RP-F10 Series Technical Reference

GS '(' 'L' pL pH '0' fn 'K' 'C'
Code 1DH 28H 4CH pL pH 30H fn 4BH 43H
Definition Range
Function In response to the request of this command, the printer sends the key code list of the
registered NV graphics by character string.
pL, pH:
fn:
Notes When 40 or more key codes are registered, the data is divided to the upper limit of 40 key
codes and sent. The 1st character of the response shows the status of the data that follows.
The printer performs the following operations according to the transmission data from the host
device after sending the character string once.
Transmission Data
The printer does not return to normal processing until the processing is terminated or
suspended by the operations above.
Related Commands GS '(' 'L', GS '8' 'L'
GS '(' 'L' pL pH '0' fn 'C' 'L' 'R'
Code 1DH 28H 4CH pL pH 30H fn 43H 4CH 52H
Definition Range
Function Deletes all NV graphics data in batch.
pL, pH:
fn:
Notes In the standard mode, this command is valid only when there is no print data in the line buffer.
Deleting the graphics data cannot increase the remaining memory capacity. The area can be
used again as the user area by the "Defragment User Area" command (DC2 '*' '1').
Related Commands GS '(' 'L', GS '8' 'L'
pL = 4, pH = 0
fn = 64
Number of bytes of the following parameter
Function selection number
Response Data
40H
41H
Preceding status 40H: Terminates processing
06H
Preceding status 41H: Sends next data group
15H Resends preceding data group
Even when following data exists, processing is aborted and
18H
terminated.
See "6.4 RESPONSE DATA".
pL = 5, pH = 0
fn = 65
Number of bytes of the following parameter
Function selection number

Send Registered NV Graphics Key Code List

Status
No following data exists
Following data exists
Operation

Delete NV Graphics Data in Batch

6-51