Table of Contents
Advertisement
DC2 'l' n
Code
12H 6CH n
Definition Range
Function In response to the request of this command, the printer sends the MS setting.
Notes
Sends the values of all MS currently set.
See "Chapter 4 Function Settings" for the meaning of MS.
The response is sent by 40 bytes in a HEX code format.
The number of data bytes to be sent is 2 bytes of header and footer + 40 × 2 = 82 bytes.
Related Commands DC2 'w'
DC2 'q' n
Code
12H 71H n
Definition Range
Function At the moment that this command has been processed, the printer sends the specified
response code.
Notes
Specify the response code by n. The low order 4 bits are valid for n. The code to be sent is the
code from 80H to 8FH, which is the logical sum of the low order 4 bits of the specified n and
80H.
The printer has an input buffer of 4096 bytes, and input and execution of command/data are
not synchronized. Therefore, the command execution completion cannot be confirmed from
outside. This command enables the completion of command execution to be confirmed from
outside. To confirm the end of the command, input this command following those commands.
The response to this command is sent after the command input immediately before is ended.
Related Commands See "6.4 RESPONSE DATA".
DC2 't'
Code
12H 74H
Function Performs a test print.
Notes
All setting values by commands are initialized.
The line buffer is cleared when executing the test print.
ESC 'c' '5' n
Code
1BH 63H 35H n
Definition Range
Default
n = 0
n = 0
See "6.4 RESPONSE DATA".
0 ≤ n ≤ 255
0 ≤ n ≤ 255
Execution Response Request
Enable/Disable Panel Switch
6-93
Send Function Settings
Test Print
Advertisement
Chapters
Table of Contents
