Set Print Speed; Execute Power Off; Dc2 'U' 0; Set Iserialnumber - Seiko RP-F10 Series Technical Reference

GS 's' n
Code 1DH 73H n
Definition Range
Function Sets the print speed.
High:
Middle (Quality): Decreases the maximum print speed for printing image to 200 mm/s to
Middle (Silent):
Notes The speed may be lower than the selected maximum speed due to the thermal head driving
method, environmental temperature, communication method, and so on.
The initial state can be selected using the Function Setting MS4-7 (Maximum Print Speed
Selection).
GS 'O'
Code 1DH 4FH
Function Performs power off processing after the value of the maintenance counter is saved and the
interface goes offline. No data is processed after this command is executed.
Notes To return to the printable state, the POWER Switch should be turned on again.

DC2 'u' 0

Code 12H 75H 00H
Function Sets the printer's serial number to iSerialNumber.
Notes It may break the FLASH memory when this command is frequently used.
Use this command only when the printer is installed, and do not use it during normal
operation.
0 ≤ n ≤ 3
n
0 High
1 Middle (Quality)
2 Reserved
3 Middle (Silent)
Drives at the maximum print speed of 250 mm/s.
improve the print quality. Printing of image includes the following:
Raster bit image, graphics data stored in print buffer, NV graphics,
downloaded bit image, bit image mode, barcode, two-dimensional barcode
Printing in the page mode, the whole page is regarded as image.
Decreases the maximum print speed to 150mm/s to print silently.
Speed Setting
6-103

Set Print Speed

Execute Power Off

Set iSerialNumber