Set Print Area In - Seiko RP-F10 Series Technical Reference

ESC 'T' n
Code 1BH 54H n
Definition Range
Default MS13-2 (180° Reverse Function Selection) is set to Disable: n = 0
MS13-2 (180° Reverse Function Selection) is set to Enable: n = 2
Function Specifies the print direction and starting point of characters in page mode.
Notes When the standard mode is selected, inputting this command executes only the internal flag
operation of the printer.
The setting of this command does not affect the standard mode.
The mapping start position of characters is the starting point in the print area specified by the
"Set Print Area in Page Mode" command (ESC 'W').
The parameter (x or y) of the basic calculation pitch used for the following commands differs
depending on the starting point.
When the starting point is "upper left" or "lower right" (Characters are mapped in the direction
perpendicular to paper feed.)
Commands that use x: ESC SP, ESC '$', ESC '\', FS 'S'
Commands that use y: ESC '3', ESC 'J', GS '$', GS '\'
When the starting point is "upper right" or "lower left" (Characters are mapped in the paper
feed direction.)
Commands that use x: ESC '3', ESC 'J', GS '$', GS '\'
Commands that use y: ESC SP, ESC '$', ESC '\', FS 'S'
Related Commands ESC '$', ESC 'L', ESC 'W', ESC '\', GS '$', GS 'P', GS '\'
0 ≤ n ≤ 3, 48 ≤ n ≤ 51
n Print Direction
0, 48 Left to right
1, 49 Bottom to top
2, 50 Right to left
3, 51 Top to bottom
See "6.3.2 Page Mode".
A
B
Select Print Direction in Page Mode
Starting Point
Upper left (A in the figure below)
Lower left (B in the figure below)
Lower right (C in the figure below)
Upper right (D in the figure below)
Paper feed direction
D
Print area
C
6-39