Table 3-10 Print Communication Protocol (Tcp Socket Port); Table 3-11 Protocol For Getting And Setting The Status; Table 3-12 Protocol For Monitoring Settings - Seiko RP-F10 Series Technical Reference

TCP Socket Port:

Table 3-10 Print Communication Protocol (TCP Socket Port)

Port type
Port No.
Port communication direction
Maximum number of
concurrent connections
Number of printable
connections
Timeout
Protocol for getting and setting the status:

Table 3-11 Protocol for Getting and Setting the Status

Port No.
HTTP version
Protocol for monitoring settings:
SNMP version
Server port No.
Trap transmission port No.
Trap destination
Enabled PDU
Community name
Enabled MIB
Protocol for Firmware update:
Transfer request port No.
Maximum number of
concurrent connections
Transfers print data and printer status through the bidirectional direct
socket communication.
Direct print TCP communication port
9100
Bidirectional
14 (It changes depending on the connection situation of other
protocols such as LPR.)
1 (Other users wait the completion of printing.)
Approx. 5 minutes (This value is changeable.)
80
HTTP/1.1
Monitors and sets settings using the SNMP protocol.

Table 3-12 Protocol for Monitoring Settings

SNMPV2
161
162
One IP address can be set (the initial status is not set)
Get Request, Get Next Request, Get Response, Set Request
Public
Part of MIB-II (RFC1213)
Upgrades the firmware of the LAN module using the TFTP
protocol.
Table 3-13 Protocol for F/W Update
69
1
3-9
Gets and changes the printer status and network
parameters on the specified Web page using the
HTTP protocol.