2.4 DRAWER KICK PORT SPECIFICATIONS
(1) Drawer Kick Port Specifications
Output voltage
Output current
Number of drive circuits
Drawer switch input
Drawer switch drive voltage
Drawer switch drive current
Drawer switch input signal level
(NOTE) • Use the coil (solenoid) whose resistance is 24 Ω or more for drawer (external device).
• Two circuits cannot be driven at the same time.
(2) Drawer Kick Connector Specifications
Printer side connector: MJ-66J-RD315 (JST) equivalent (6P modular jack connector)
Cable side connector:
Terminal No.
1
2
3
4
5
6
・Status of the terminal No.3 (SW) can be detected by "Enable/Disable Automatic Status Back" command (GS 'a').
(NOTE) • Do not connect the phone line to this connector.
Table 2-8 Drawer Kick Port Specifications
Item
TM3P-66 (HRS) equivalent
Drawer solenoid
ドロワソレノイド
Drawer switch
ドロワスイッチ
Drawer solenoid
ドロワソレノイド
Terminal Name
Input/Output Direction
FG
DR1
SW
24.0 V
DR2
GND
Figure 2-7 Drawer Kick Connector Circuit Sample
Specifications
24.0 V
1.0 A max.
2 circuits
1 port
3.3 V
0.11 mA
L: 0.0 to 0.6 V
H: 2.2 to 3.3 V
Printer inside
プリンタ内部
-
Frame ground
Output
Drive circuit 1
Input
Drawer switch input
-
-
Output
Drive circuit 2
-
Signal ground
2-14
Function