Cutter Specifications; Figure 2-5 Cut Position; Table 2-5 Cutter Specifications - Seiko RP-F10 Series Technical Reference

2.2 CUTTER SPECIFICATIONS

(1) Cutter Specifications
Paper cutting method
Cutting frequency
(2) Cut Position
Paper feed direction
Paper
direction
Symbol
A Remaining part of partial cut
B Distance from cut position to thermal head heat element
C Distance from cut position to backward feed margin
Distance from paper edge (1st
D
dot side) to partial cut position
(3) Precautions for Using Cutter
Pulling the thermal paper strongly after partial cut may result in uneven pitch because stress is applied
to the platen. Feed the thermal paper approx. 1 mm before starting next printing.
Do not cut the thermal paper over maximum cutting frequency because it may damage the cutter.
Leaving the printer for a long time in the situation where the cutting is completed may cause paper jam
at the next printing. Execute paper feed or print 2 mm or more after cutting operation.

Table 2-5 Cutter Specifications

Item
Slide cutting
1 cut / 2 sec max.
D
Cut position
Cut position
Back feed margin
feed
Thermal head heat element

Figure 2-5 Cut Position

Specifications
A
Printing surface
Item
Paper width: 80 mm
Paper width: 58 mm
2-12
C
B
Dimension
Approx. 1.35 mm
Approx. 9.5 mm
7.5 mm
Approx. 40 mm
Approx. 29 mm