Dc2 'R' N Initialize User Area; Dc2 'K' F [D]K Nul Change Function Settings - Seiko RP-F10 Series Technical Reference

DC2 'R' n
Code 12H 52H n
Definition Range
Function Initializes the user area (FLASH memory).
Notes All user-defined characters, downloaded characters, optional fonts, downloaded bit images,
macros, NV graphics, User page 1-byte fonts, and User page international characters are
cleared and returned to the initial state. (The area for user-defined characters and downloaded
characters are allocated.)
The Function Settings and the maintenance counter are not initialized.
When n is out of the definition range, this command is ignored.
DC2 'k' f [d]k NUL
Code 12H 6BH f [d]k 00H
Definition Range
Function Sets all MS in a batch.
Sets the following function. The setting value is valid from when the command is executed.
f = 00H: Does not write to the system area of the FLASH memory at the same time as
f = 80H: Writes to the system area of the FLASH memory at the same time as setting.
Specify the total 40 bytes of MS1 to 40 continuously.
Notes Do not set f = FFH. The printer may not work properly.
The printer is initialized after execution of this command.
However, initialization operation of the cutter is not performed.
Do not turn off the power while executing this command.
See "Chapter 4 Function Settings" for each content of MS.
Execute software reset or hardware reset to enable the setting when MS39 is changed.
Related Commands DC2 'w'
n = 1
f = 0, 128
0 ≤ d ≤ 255
k = 40
setting.
MS39 (Bluetooth Setting) is not changed.
6-91
Initialize User Area
Change Function Settings