Ruled Line; Dc3 '#' N Select Ruled Line Overlapping Mode; Dc3; Dc3 '+' Set Ruled Line On - Seiko RP-F10 Series Technical Reference

6.5.11 Ruled Line

DC3 '#' n
Code 13H 23H n
Definition Range
Default Ruled line OR overlapping mode
Function Specifies OR or XOR for the overlapping mode of ruled line with character and image data.
When n = <*******0>B, the OR overlapping mode is specified.
When n = <*******1>B, the XOR overlapping mode is specified.
Notes Only the LSB is valid for n.
When the page mode is selected, inputting this command executes only the internal flag of
the printer. The setting of this command does not affect the page mode.
When the OR overlapping mode is specified, the part where dots exist either in the ruled line
or in the image and character is printed out in black.
XOR shows exclusive OR. When the XOR overlapping mode is specified, the part where the
ruled line is overlapped with the image and character is printed out in white, and the
non-overlapped part is printed out in black.

DC3 '('

Code 13H 28H
Function Following input of this command, the printer accepts ruled line commands without DC3 code
until it receives 29H.
Notes All commands other than ruled line commands are ignored.
DC3 '+'
Code 13H 2BH
Default Ruled line OFF
Function Sets the ruled line to ON.
Notes After this command, ruled line is printed in the following cases:
(1) Printing characters and spaces between lines
(2) Execution of the "Line Feed" command (LF), "Print and Feed Forward" command (ESC 'J'),
"Print and n Lines Feed Forward" command (ESC 'd'), "Print Ruled Line 1 Dot-Line"
command (DC3 'P'), or "Print Ruled Line n Dot-Lines" command (DC3 'p')
This command is valid until the "Set Ruled Line OFF" command (DC3 '-') is executed.
The dots whose bit of the selected ruled line buffer is 1 are printed out.
･ In the page mode:
The ruled line data beyond the print area set in "Set Print Area in Page Mode" command
(ESC 'W') is not printed.
･ In the standard mode:
The ruled line data of the printable area width is always printed.
Related Commands DC3 '-', ESC '#'
0 ≤ n ≤ 255
Select Ruled Line Overlapping Mode
Specify Ruled Line Command
6-110
Set Ruled Line ON