Dc3 'D' Nl Nh Set Ruled Line (Unit: Dot); Dc3 'F' N1 N2 Fill Ruled Line Pattern; Dc3 'L' Ml Mh Nl Nh Set Ruled Line (Unit: Dot-Line) - Seiko RP-F10 Series Technical Reference

DC3 'D' nl nh
Code 13H 44H nl nh
Definition Range
Default All ruled lines cleared
Function Sets the bit of the [nh × 256 + nl]th dot of the selected ruled line buffer to 1.
Notes The position of the dot is counted by regarding the dot on the left edge of the screen as
position 0.
The specification exceeding the printable area is ignored. At this time, the maximum value of
the printable area is not the maximum width (X direction), but the maximum length (Y
direction) in consideration of rotate 90° in the page mode.
The specified data by this command is added on the selected ruled line buffer.
DC3 'F' n1 n2
Code 13H 46H n1 n2
Definition Range
Default All ruled lines cleared
Function Fills the selected ruled line buffer with 2 bytes of data specified by n1 and n2.
Notes The ruled line buffer is filled with a repetitive pattern of 16-dot image in which n1 is 8 dots on
the left side and n2 is 8 dots on the right side.
The correspondence of each bit and dots of n1 and n2 can be changed by the "Select Image
LSB/MSB" command (DC2 '='). (In the initial state, MSB is on the left side.)
The specification exceeding the printable area is ignored. At this time, the maximum value of
the printable area is not the maximum width (X direction), but the maximum length (Y
direction) in consideration of rotate 90° in the page mode.
The specified data by this command is overwritten on the entire area of the selected ruled line
buffer.
Related Commands DC2 '='
DC3 'L' ml mh nl nh
Code 13H 4CH ml mh nl nh
Definition Range
Default All ruled lines cleared
Function Sets the bits in the range from the [mh × 256 + ml]th dot to the [nh × 256 + nl]th dot of the
selected ruled line buffer to 1.
Notes The position of the dot is counted by regarding the dot on the left edge of the screen as
position 0.
The specification exceeding the printable area is ignored. At this time, the maximum value of
the printable area is not the maximum width (X direction), but the maximum length (Y
direction) in consideration of rotate 90° in the page mode.
The specified data by this command is overwritten on the specified area of the selected ruled
line buffer.
0 ≤ nl ≤ 255, 0 ≤ nh ≤ 255
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
0 ≤ ml ≤ 255, 0 ≤ mh ≤ 255
0 ≤ nl ≤ 255, 0 ≤ nh ≤ 255
Set Ruled Line (Unit: Dot-Line)
6-112
Set Ruled Line (Unit: Dot)
Fill Ruled Line Pattern