Initialization By Software Resetting; Initialization By Hardware Resetting - Seiko RP-F10 Series Technical Reference

7.2 INITIALIZATION BY SOFTWARE RESETTING

Initialization is performed by the following commands or operation.
• Resetting of USB class request (Valid only by printer driver)
• "Reset Download Mode" command ('@') (Valid only in download mode)
• "Printer Reset" command (DC3 '(' 'r' 'e' 's' 'e' 't' DC3 'r' 'e' 's' 'e' 't' ')')
By this initialization, in addition to the items in "7.2 INITIALIZATION OF SETTINGS", the items in Table 7-2
are initialized.
Also, the Bluetooth interface is initialized. When the interfaces are initialized, the communications are
disconnected.
Table 7-2 Setting Value After Initialized by Software Resetting
Input buffer
Output buffer
Function Settings
Macro
Peripheral device selection
Panel switch enable/disable
Automatic status back enable/disable
Thermal head driving method
Print density
Print speed

7.3 INITIALIZATION BY HARDWARE RESETTING

Initialization is performed by the following commands or operation.
• "Hardware Reset" command (DC2 '@')
• Power on by the POWER Switch
By this initialization, the items in "7.2 INITIALIZATION OF SETTINGS" and "7.3 INITIALIZATION BY
SOFTWARE RESETTING " are initialized.
Also, all interfaces are initialized. When the interfaces are initialized, the communications are disconnected.
Item Setting Value
Clear
Clear
Depends on Function Settings DC2 'k', DC2 'w'
Cancel
Printer enabled
Enabled
Depends on Function Settings GS 'a'
Depends on Function Settings DC2 '>', DC2 '%'
Depends on Function Settings DC2 '~'
Depends on Function Settings GS 's'
7-4
Command
-
-
GS ':'
ESC "="
ESC 'c' '5'