Switch Settings - YASKAWA JANCD-YEW01-E Instructions Manual

Interface Board for Welding
Power Supply
3.2
3 Function Settings

3.2 Switch Settings

Switch Settings
Switch How to set
S1
Station setting
Sets the station.
The relations of the switch settings and the stations are
shown below.
Set the arrow to the number corresponding to the desired
station by using a precision screwdriver (Phillips or
flathead).
0: Not available
1: ST#01 (factory setting)
2: ST#02
3: ST#03
4: ST#04
5: ST#05
6: ST#06
7: ST#07
The number after ST# is the station number which is
displayed on the programming pendant screen when
setting the I/O module.
SW1
1
Transfer rate
setting
4 Mbps 10 Mbps
1
4 Mbps 10 Mbps
SW2
1
I/O communication
mode setting
17 BYTE/32 BYTE
1
17 BYTE/32 BYTE
• Do not set S1 to 0, E, or F. Also, do not set 2 or more
boards to the same station. Otherwise, this board cannot
be recognized correctly.
NOTE
• Do not set SW1 to 10 Mbps. If it is set to 10 Mbps, this
board cannot be recognized correctly.
• Do not set SW2 to 32 BYTE. If it is set to 32 BYTE, this
board cannot be recognized correctly.
3-2
8: ST#08
9: ST#09
A: ST#10
B: ST#11
C: ST#12
D: ST#13
E: Not available
F: Not available
1 to 2 short circuit: 4 Mbps
SW1
(factory setting)
3
* Must be set to 4 Mbps.
2 to 3 short circuit: 10 Mbps
SW1
* Not available
3
1 to 2 short circuit: 17 BYTE
SW2
(factory setting)
3
* Must be set to 17 BYTE.
2 to 3 short circuit: 32 BYTE
SW2
* Not available
3
HW1481264
167646-1CD
16 of 40