Connector Cn3 For Keypad; Service Switch; Neuron Id; Initializing Bind Data - YASKAWA LonWorks SI-W3 Installation Manual

Terminal
◆

Connector CN3 for Keypad

Note:
• The Z1000 and Z1000U do not support this connector and associated DDC functions.
• Digital operator model JVOP-180 and JVOP-183 are not compatible.
DANGER
energized drive. Before servicing, disconnect all power to the equipment and wait for the time specified on
the warning label at a minimum. The internal capacitor stays charged after the drive is de-energized. The
charge indicator LED extinguishes when the DC bus voltage decreases below 50 Vdc. When all indicators
are OFF, remove the covers before measuring for dangerous voltages to make sure that the drive is safe.
If you do work on the drive when it is energized, it will cause serious injury or death from electrical shock.
Use an RJ-45 cable to connect a digital operator (model: JVOP-182) to connector CN3 to
set Direct Digital Control (DDC) function parameters.
◆

Service Switch

The service switch is a neuron ID output switch. Push this switch to output the neuron ID
to the network.
■

Neuron ID

A label showing the neuron ID is on the option PCB. Refer to page
information.
A bar code label for the neuron ID is on the option and there are additional labels in the
packaging.
■

Initializing Bind Data

To clear the bind data and reset the configuration properties to the default settings, hold
down the service switch and cycle power.
Note:
Do not turn off the power to the drive while you initialize the bind data. RUN, RX, TX, and ERR LEDs are lit
(ON) during initialization of the bind data.
◆

Option LED States

The option has five LEDs:
YASKAWA TOEP C730600 93B LonWorks Installation Manual
Table 4.1 Terminal Descriptions
Terminal No.
1
2
3
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an
4 Option Components
Name
A Signal Line A
SLD Shield
B Signal Line B
Figure 4.1
Description
for more
13