Slot For Storage Media; Buffering Mechanisms; Operating Mode Switch - YASKAWA VIPA System MICRO M13-CCF0000 Manual

Hardware description
Structure > Operating mode switch

3.2.5 Slot for storage media

Overview

3.2.6 Buffering mechanisms

3.2.7 Operating mode switch

General
42
In this slot you can insert the following storage media:
n VSD - VIPA SD-Card
– External memory card for programs and firmware.
n VSC - VIPASetCard
– External memory card (VSD) for programs and firmware with the possibility to
unlock optional functions like work memory and field bus interfaces.
– These functions can be purchased separately.
storage media - VSD, VSC' on page 79
– To activate the corresponding card is to be installed and a Overall reset is to be
Ä Chapter 4.12 'Overall reset' on page 75
established.
A list of the currently available VSD respectively VSC can be found at
www.vipa.com
The CPU has a capacitor-based mechanism to buffer the internal clock in case of power
failure for max. 30 days. With PowerOFF the content of the RAM is automatically stored
in the Flash (NVRAM).
CAUTION!
Please connect the CPU for approximately 1 hour to the power supply, so
that the internal buffering mechanism is loaded accordingly.
In case of failure of the buffer mechanism Date and Time 01.09.2009
00:00:00 set. Additionally, you receive a diagnostics message.
4.19 'Diagnostic entries' on page 85
n With the operating mode switch you may switch the CPU between STOP and RUN.
n During the transition from STOP to RUN the operating mode START-UP is driven by
the CPU.
n Placing the switch to MR (Memory Reset), you request an overall reset with following
load from memory card, if a project there exists.
VIPA System MICRO
Ä Chapter 4.15 'Deployment
HB400 | CPU | M13-CCF0000 | en | 16-47
Ä Chapter