Table of Contents
Advertisement
Chapter 2 Preparations
1.23
Front DisplayPort Expansion Kit N8117-05
The front of the 3.5-inch x4 drive model supports DisplayPort/USB
Installing Front DisplayPort Expansion Kit N8117-05
Please prepare the following before installing the options.
Parts included in the option kit
T-10 hexalobular driver
To install the components, follow these steps.
1.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
Remove the screws (x2) holding the front DisplayPort/USB blank cover and pull the blank cover forward to
remove it.
3.
Pass the module cable through the front of the server, then install the module body.
DisplayPort/USB extension bay
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
147
Advertisement
Table of Contents
