Table of Contents
Advertisement
TABLE D-5
ASC
Byte 12
80h
80h
80h
80h
85h
D.2.4
Unit Attention—Sense Key 6h
The tape library does not stack Unit Attention conditions. The tape library reports
only the last Unit Attention condition when there are two or more Unit Attention
conditions. A Unit Attention condition remains in effect for a particular initiator
until that initiator clears it.
TABLE D-6
key (6h).
TABLE D-6
ASC
Byte 12
28h
28h
28h
28h
29h
2Ah
3Fh
Illegal Request Sense Key (5h) ASC and ASCQ Values (Continued)
ASCQ
Description
Byte 13
03h
The source cartridge magazine is not installed.
04h
The destination cartridge magazine is not installed.
05h
The source tape drive is not installed.
06h
The destination tape drive is not installed.
01h
The bar code scanner is not installed.
lists combinations of ASC and ASCQ values for the Unit Attention sense
Unit Attention Sense Key (6h) ASC and ASCQ Values
ASCQ
Description
Byte 13
00h
The door was opened then closed.
89h
The tape library was placed in SCSI Interface mode after operating in
one of the serial port modes.
8Dh
The tape library was placed in SCSI Interface mode after operating in
LCD mode.
8Eh
The tape library was placed in SCSI Interface mode after operating in
one of the sequential modes (Sequential CTS1, Sequential CTS2, or Dual
Sequential).
00h
A power-on, SCSI bus reset, or device reset message occurred.
01h
Mode parameters have been changed. Issue a MODE SENSE (1Ah)
command to determine what the new mode parameters are.
01h
New microcode was loaded.
Appendix D
Error Codes
D-13
Advertisement
Table of Contents
