1
CHAPTER
Installing and Configuring a Sun
StorEdge T3 or T3+ Array
This chapter contains the procedures about how to install and configure Sun™
StorEdge™ T3 and Sun StorEdge T3+ arrays in a single-controller (noninterconnected)
or partner-group (interconnected) configuration in a Sun™ Cluster environment.
This chapter contains the following topics.
"Installing Sun StorEdge T3 and T3+ Arrays" on page 11
I
I
"Configuring Sun StorEdge T3 and T3+ Arrays" on page 38
For information about how to use a storage array in a storage area network (SAN), see
"SAN Solutions in a Sun Cluster Environment" in Sun Cluster 3.0-3.1 Hardware
Administration Manual for Solaris OS.
Installing Sun StorEdge T3 and T3+
Arrays
This section contains the procedures about how to install storage arrays in a cluster.
The following table lists these procedures.
TABLE 1–1
Task
Installing arrays in a new cluster, using a
single-controller configuration
Task Map: Installing a Storage Array
Information
"How to Install a Storage Array in a
New Cluster Using a
Single-Controller Configuration"
on page 12
11