Protective Covers; Protective Covers; Ip20/Open-Chassis; Ip20/Nema Type 1 - YASKAWA V1000 Series Technical Manual

3.5

Protective Covers

Follow the procedure below to remove the protective covers before wiring the drive and to reattach the covers after wiring is complete.

IP20/Open-Chassis

u
Removing the Protective Covers
n
1.
Loosen the screw that locks the front cover in place to remove.
2.
Apply pressure to the tabs on each side of the terminal cover. Pull the terminal cover away from the drive while pushing in on the tabs to pull the
cover free.
Reattaching the Protective Covers
n
Properly connect all wiring and route power wiring away from control signal wiring. Reattach all protective covers when wiring is complete. Apply only
a small amount of pressure to lock the cover back into place.
u

IP20/NEMA Type 1

Removing the Protective Covers on an IP20/NEMA Type 1 design
n
1.
Loosen the screw on the front cover to remove the front cover.
2.
Loosen the screw on the terminal cover (
YASKAWA ELECTRIC SIEP C710606 18A YASKAWA AC Drive – V1000 Technical Manual (Preliminary)
Figure 3.10 Remove the Front Cover on an IP20/Open-Chassis Drive
Figure 3.11 Remove the Terminal Cover on an IP20/Open-Chassis Drive
Figure 3.12 Reattach the Protective Covers on an IP20/Open-Chassis Drive
Figure 3.13 Remove the Front Cover on an IP20/NEMA Type 1 Drive
, B) to remove the terminal cover and expose the conduit bracket (
Figure 3.14

3.5 Protective Covers

3
, A).
Figure 3.14
39