YASKAWA V1000 Series Technical Manual page 40

3.5 Protective Covers
3.
Loosen two screws attaching the conduit bracket (
Reattaching the Protective Covers
n
Pass power wiring and control signal wiring through the exit holes on the bottom of the conduit bracket of the drive. Place power wiring and control signal
wiring in separate conduits. Properly connect all wiring after installing the drive and connecting other devices. Reattach all protective covers when wiring
is complete.
40
Figure 3.14 Remove the Terminal Cover on an IP20/NEMA Type 1 Drive
Figure 3.15
A
Figure 3.15 Remove the Conduit Bracket on an IP20/Open-Chassis Drive
A – Pass power wiring and control signal wiring through different exit holes at the bottom
of the drive.
Figure 3.16 Reattach the Protective Covers and Conduit Bracket on an IP20/NEMA Type 1 Drive
A
B
, A) to remove.
A
YASKAWA ELECTRIC SIEP C710606 18A YASKAWA AC Drive – V1000 Technical Manual (Preliminary)