Acceleration/Deceleration: C1-01 To C1-11 - YASKAWA V1000 Series Technical Manual

4.6 Basic Drive Setup Adjustments
Run Command
Output Frequency
DC Injection Braking
Motor Speed
*See Figure 4.18
Note: Extend baseblock time (L2-03) if overcurrent (OC) occurs on stop command input.
Coast to Stop with Timer: Ignoring a Run Command Input within the Deceleration Time: b1-03 = 3
n
When b1-03 = 3, a stop command interrupts drive output and the motor coasts to stop. The drive will not accept the next run command until time "t" has
passed. Time "t" is determined by the output frequency at the moment the stop command was entered and the deceleration time set to the drive according
to Figure 4.20 .
u

Acceleration/Deceleration: C1-01 to C1-11

C1-01 (Acceleration Time 1) sets the time to accelerate from 0 to the maximum output frequency (E1-04). C1-02 (Deceleration Time 1) sets the time to
decelerate from maximum output frequency to 0.
No. Parameter Name
C1-01 Acceleration Time 1
<1>
C1-02 Deceleration Time 1
<1>
80
ON
DC Injection Braking Time
b2-04 x 10
b2-04
10%
Figure 4.19 DC Injection Braking Stop
Run Command
Output Frequency
Drive output voltage interrupted
Operation wait time t
Deceleration time
(C1-02, etc.)
Minimum
Baseblock Time
(L2-03)
Minimum Output Frequency
Figure 4.20 Coast to Stop with Timer
Sets the time to accelerate from 0 to 100% (maximum output frequency).
Sets the time to decelerate from 100% (maximum output frequency) to 0%.
OFF
Minimum Baseblock Time (L2-03)
DC Injection Braking
DC Braking
Time at Stop
Current (b2-02)
(b2-04)*
Output frequency when
stop command was entered
100%
(Max Output Frequency)
ON OFF ON OFF ON
Operation Wait Time t
Output frequency when
stop command was entered
100%
(Max Output Frequency)
Description
YASKAWA ELECTRIC SIEP C710606 18A YASKAWA AC Drive – V1000 Technical Manual (Preliminary)
Setting Range Default
0.0 to 6000.0 10.0 s
<2>