Cabling The 4X 3.5-Inch Hdd Extension Box; Installing Hdd Modules Into The 4X 3.5-Inch Hdd Extension Box - Fujitsu PRIMERGY RX2560 M2 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state drive (SSD)
7.4.5.6

Cabling the 4x 3.5-inch HDD extension box

Figure 162: Connecting cables to the 4x 3.5-inch HDD extension box
Ê Connect the SAS cable C11 from backplane connector X9 to the expander
board connector X12 (1).
Ê Connect the power cable C6 from backplane connector X40 to the system
board connector PWR 12V3 (2).
Ê If applicable, connect the power cable and the SATA cable of the ultraslim
ODD to the system board (see section
page 418).
Ê If applicable, connect the OOB cable (see cabling plan in
page 530).
I
For a complete cabling overview, please refer to section
on page 512.
7.4.5.7

Installing HDD modules into the 4x 3.5-inch HDD extension box

Ê Install HDD modules or HDD dummy modules into the additional HDD bays
as described in sections
and "Installing a 3.5-inch HDD dummy module" on page
I
For detailed information on HDD mounting order, refer to section
inch HDD configurations" on page
250
"Installing a 3.5-inch HDD module" on page 219
Upgrade and Maintenance Manual
"Installing the ultraslim ODD" on
206.
TX2560 M2 / RX2560 M2
figure 402 on
"Cabling plans"
221.
"3.5-