Parameter Descriptions; Parameter Selection - Danfoss VLT AutomationDrive FC 302 Programming Manual

Parameter Descriptions

3 Parameter Descriptions

3.1 Parameter Selection

3 3
Parameters are grouped into various parameter groups for
easy selection of the correct parameters for optimised
operation of the frequency converter.
0-** Operation and Display parameters
•
Basic Settings, set-up handling
•
Display and Local Control Panel parameters for
selecting readouts, setting up selections and
copying functions
1-** Load and Motor parameters include all load and
motor related parameters
2-** Brake parameters
•
DC brake
•
Dynamic brake (Resistor brake)
•
Mechanical brake
•
Overvoltage Control
3-** References and ramping parameters include DigiPot
function
4-** Limits Warnings; setting of limits and warning
parameters
5-** Digital inputs and outputs include relay controls
6-** Analog inputs and outputs
7-** Controls; Setting parameters for speed and process
controls
8-** Communication and option parameters for setting of
RS-485 and USB port parameters.
9-** Profibus parameters
10-** DeviceNet and CAN Fieldbus parameters
12-** Ethernet parameters
13-** Smart Logic Control parameters
14-** Special function parameters
15-** Drive information parameters
24
®
VLT AutomationDrive FC 301/302 Programming Guide
16-** Readout parameters
17-** Encoder Option parameters
18-** Readout 2 parameters
30-** Special Features
32-** MCO Basic Settings parameters
33-** MCO Adv. Settings parameters
34-** MCO Data Readouts
35-** Sensor Input Option parameters
NOTICE
To see if a parameter can be used in a specific control
mode, use Table 4.3.
MG33MI02 - Rev. 2013-11-20