Danfoss VLT AutomationDrive FC 302 Programming Manual page 124

Parameter Descriptions
8-57 Profidrive OFF2 Select
Select control of the frequency converter OFF2 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
3 3
Profidrive profile.
Option:
[0]
[1]
[2]
[3]
*
8-58 Profidrive OFF3 Select
Select control of the frequency converter OFF3 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
Profidrive profile.
Option:
[0]
[1]
[2]
[3]
*
3.10.6 8-8* FC Port Diagnostics
These parameters are used for monitoring the Bus
communication via the FC Port.
8-80 Bus Message Count
Range:
0 [0 - 0 ] This parameter shows the number of valid
*
8-81 Bus Error Count
Range:
0 [0 - 0 ] This parameter shows the number of telegrams
*
8-82 Slave Messages Rcvd
Range:
0 [0 - 0 ] This parameter shows the number of valid
*
8-83 Slave Error Count
Range:
0 [0 - 0 ] This parameter shows the number of error
*
122
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
telegrams detected on the bus.
Function:
with faults (e.g. CRC fault), detected on the bus.
Function:
telegrams addressed to the slave, sent by the
frequency converter.
Function:
telegrams, which could not be executed by the
frequency converter.
®
VLT AutomationDrive FC 301/302 Programming Guide
3.10.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM
MG33MI02 - Rev. 2013-11-20
Function:
[ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
Function:
[ 0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.